IT업계 취업 준비생이라면 국제적으로도 승인받는 IT인증자격증 정도는 몇개 취득해야 하지 않을가 싶습니다. EMC인증 E20-816시험을 통과하여 인기 자격증을 취득하시면 취업경쟁율이 제고되어 취업이 쉬워집니다. ITExamDump의EMC인증 E20-816덤프는 많은 시험본 분들에 의해 검증된 최신 최고의 덤프공부자료입니다.망설이지 마시고ITExamDump제품으로 한번 가보세요.
EMC인증 E20-816시험을 패스해서 자격증을 취득하려고 하는데 시험비며 학원비며 공부자료비며 비용이 만만치 않다구요? 제일 저렴한 가격으로 제일 효과좋은ITExamDump 의 EMC인증 E20-816덤프를 알고 계시는지요? ITExamDump 의 EMC인증 E20-816덤프는 최신 시험문제에 근거하여 만들어진 시험준비공부가이드로서 학원공부 필요없이 덤프공부만으로도 시험을 한방에 패스할수 있습니다. 덤프를 구매하신분은 철저한 구매후 서비스도 받을수 있습니다.
EMC인증 E20-816시험취득 의향이 있는 분이 이 글을 보게 될것이라 믿고ITExamDump에서 출시한 EMC인증 E20-816덤프를 강추합니다. ITExamDump의EMC인증 E20-816덤프는 최강 적중율을 자랑하고 있어 시험패스율이 가장 높은 덤프자료로서 뜨거운 인기를 누리고 있습니다. IT인증시험을 패스하여 자격증을 취득하려는 분은ITExamDump제품에 주목해주세요.
시험 번호/코드: E20-816
시험 이름: EMC (Symmetrix Solutions Expert Exam for Technology Architects)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 156 문항
업데이트: 2013-11-26
EMC인증 E20-816시험을 패스하여 자격증을 취득하시면 찬란한 미래가 찾아올것입니다. EMC인증 E20-816인증시험을 패스하여 취득한 자격증은 IT인사로서의 능력을 증명해주며 IT업계에 종사하는 일원으로서의 자존심입니다. ITExamDump 의 EMC인증 E20-816덤프는 시험패스에 초점을 맞추어 제일 간단한 방법으로 시험을 패스하도록 밀어주는 시험공부가이드입니다.구매전EMC인증 E20-816무료샘플을 다운받아 적성에 맞는지 확인하고 구매할지 않할지 선택하시면 됩니다.
E20-816 덤프무료샘플다운로드하기: http://www.itexamdump.com/E20-816.html
NO.1 A customer is planning to implement SRDF/S into their environment. The customer wants zero data
loss if they lose their primary data center (R1). The distance is 1,000 miles, and the customer would like to
maintain an application response time of 10 ms.
Which design would you implement?
A. SRDF/AR single-hop
B. SRDF/AR multi-hop
C. SRDF/DM
D. SRDF/S with adaptive copy initially
Answer: B
EMC인증 E20-816 E20-816
NO.2 A customer's application is stored on a DMX-4. The application runs 24x7x365. They would like to send
consistent replicas of this data simultaneously to four branch offices on a nightly basis. The branch offices
have CLARiiON arrays.
Which solution would you recommend?
A. Use TimeFinder/Mirror to create a consistent replica of the production application. Then use Open
Replicator cold push to replicate the data from the BCVs to the remote offices.
B. Use Open Replicator cold push to replicate the data to the remote offices.
C. Use Open Replicator hot push to replicate the data to the remote offices.
D. Use TimeFinder/Snap to create a consistent replica of the production application. Then use Open
Replicator cold push to replicate the data on the VDEVs to the remote offices.
Answer: A
EMC덤프 E20-816 E20-816 E20-816
NO.3 The customer has a DMX-4 replicating to another DMX-4 (microcode level 5773 for both) over an
SRDF/S session between two sites 20 km apart and wants to understand the limitation (if any) of using
the Single Round Trip (SiRT) feature on RF directors. What is the applicable limitation of the setup?
A. SiRT only works for an I/O size of less than 32 KB.
B. SiRT is enabled for all block sizes.
C. SiRT would not work because the distance is greater than 12 km.
D. SiRT only works for SRDF/A.
Answer: A
EMC기출문제 E20-816덤프 E20-816
NO.4 The customer wants a TimeFinder/Snap solution to create a point in time prior to modifying the source
data for testing purposes. The snap would be kept for 8 hours. How should the Change Tracker data
collection be set up to model the solution?
A. Sum report with a reset of 4 hours
B. Delta report with a reset of 16 hours
C. Delta report with a reset of 4 hours
D. Delta report with a reset of 8 hours
Answer: D
EMC인증 E20-816자료 E20-816인증 E20-816
NO.5 The customer wants a TimeFinder/Snap solution to create a point in time prior to modifying the source
data for testing purposes with a 16-hour RPO.
How should the Change Tracker data collection be set up to model the solution.?
A. Delta report with a reset of 8 hours
B. Delta report with a reset of 16 hours
C. Delta report with a reset of 4 hours
D. Sum report with a reset of 8 hours
Answer: B
EMC시험문제 E20-816 pdf E20-816 E20-816 E20-816
NO.6 A company has a Symmetrix V-Max array in an open systems environment. They want to use
TimeFinder/Snap to create a single copy per day of a production environment containing 200 volumes of
8 GB each. Twenty-five percent of the total I/O in the application is write activity.
What is the amount of physical storage required for all VDEVs?
A. 50 GB
B. 4 GB
C. 8 GB
D. 0 GB
Answer: D
EMC인증 E20-816 pdf E20-816 E20-816
NO.7 An Open Replicator data migration from a HDS to Symmetrix array is being proposed. The customer
has the following requirements: Application downtime should be minimal and Open Replicator session
failure must not result in data loss
Which solution will meet the customer's requirements?
A. Cold pull with precopy
B. Cold pull with donor update
C. Hot pull with donor update
D. Hot pull with precopy
Answer: C
EMC pdf E20-816자격증 E20-816 dump E20-816 pdf E20-816 dumps E20-816자료
NO.8 A customer is running SRDF/A single session mode. They want to change into SRDF/S mode after
nightly periods of high write activity have completed. The switch to synchronous mode failed.
What is a potential cause for this failure?
A. SRDF/S cycle switching feature is not enabled.
B. Mode change feature is only supported with Concurrent SRDF.
C. SDRF/A write cache is not enabled at the remote site.
D. Fifty percent or more of SRDF/A write cache is in use on the target Symmetrix.
Answer: D
EMC E20-816인증 E20-816자료 E20-816자격증 E20-816
NO.9 A customer wants to migrate from DMX-3 with 5772 to DMX-4 with 5773 code. They are using
TimeFinder/Clone every night for backup processing with synchronous COFW. TimeFinder/Clone with
5773 allows them to use a new feature called asynchronous COFW.
How many back-end operations does TimeFinder/Clone make with Enginuity 5773 using Aynchronous
COFW compared with TimeFinder/Clone with Enginuity 5772?
A. Back-end operations are lower with 5773 Enginuity.
B. Back-end operations are the same in both Enginuity versions.
C. Back-end operations are higher with 5773 Enginuity.
D. Depends on disk speed and RAID protection.
Answer: B
EMC E20-816 E20-816시험문제 E20-816
NO.10 A customer is migrating their Windows 2008 servers from HP storage to EMC V-Max storage.
Host-based performance metrics need to be used to design a configuration. EMC recommends the
diskperf -Y command to enable I/O statics in every server.
Why is enabling disk statistics collection recommended?
A. It improves performance of the servers
B. Otherwise, a reboot will be required to activate
C. Otherwise, you must start Performance Monitor
D. Because Windows 2008 leaves the default value to off
Answer: B
EMC dump E20-816기출문제 E20-816 pdf E20-816 E20-816인증 E20-816자격증
NO.11 A customer has a single V-Max and you are helping to design a new SRDF solution. This customer
wants to replicate all its data with SRDF over a Gigabit Ethernet.
In order to get the maximum benefit from scaling, what is the most important consideration?
A. All GigE ports on the source should be able to see all GigE ports on the target array
B. Ports must have auto-negotiation off because we don't support Jumbo Frames
C. Speed limit value in the Symmetrix configuration file (not persistent)
D. Speed limits can be set on GigE ports from 100 to 10000 Mb (megabits)
Answer: A
EMC pdf E20-816시험문제 E20-816
NO.12 A customer is implementing a new SRDF/S environment with DMX arrays. The primary and secondary
data centers are 20 kilometers apart.
Which consideration is needed for planning, designing, and implementing a synchronous solution?
A. Ensure that the application can tolerate the additional latency
B. Ensure that adequate cache on the arrays is allocated
C. Ensure that the RAID configuration is identical on both arrays
D. Ensure that there is twice the recommended amount of bandwidth
Answer: A
EMC기출문제 E20-816 E20-816 E20-816
NO.13 The customer wants to replace the three DMX 2000s with a single Symmetrix V-Max using Open
Replicator hot pull for the move. What sequence of steps should be taken to get ready for the copy
sessions?
LUN Masking of DMX 2000 remote volumes to the V-Max FA ports.
V-Max and DMX 2000 arrays are reachable via the same fabric or SAN extension.
FA ports of V-Max are zoned to FA ports of the three DMX 2000s.
V-Max and DMX 2000 arrays are reachable via point-to-point or FC-AL.
LUN Masking of the V-Max control volumes to the DMX 2000 FA ports.
All V-Max FAs have access to the DMX 2000 volumes being migrated.
A. 4,6,1,3
B. 4,3,5,6
C. 2,3,1,6
D. 2,3,5,6
Answer: C
EMC E20-816 E20-816 dumps E20-816인증
NO.14 Click the Calculator icon in the upper left-hand corner.
SRDF/S over Fibre Channel has been configured between two V-Max arrays that are 50 kilometers apart.
What is the expected write response time delay due to latency?
A. 0.25 ms
B. 0.5 ms
C. 1 ms
D. 2 ms
Answer: C
EMC E20-816 E20-816 dump E20-816
NO.15 What are the key differences between SIRT in 5772 and SIRT in Symmetrix V-Max with 5874?
A. SIRT in 5874 is enabled for all write sizes or if RTT > 115 microsec
B. SIRT in 5874 is enabled for write sizes up to 64 KB or RTT threshold > 520 microsec
C. SIRT in 5874 is enabled for all write sizes or if RTT < 115 microsec
D. SIRT in 5874 is enabled for write sizes up to 128 KB or if RTT < 115 microsec
Answer: A
EMC자격증 E20-816최신덤프 E20-816기출문제
ITexamdump의 70-480덤프의 VCE테스트프로그램과 NS0-156덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 70-463시험에 대비한 고품질 덤프와 74-343시험 최신버전덤프를 제공해드립니다. 최고품질 CTAL-TM_Syll2012시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기